|
Customers seeking Custom-made shirts, can follow the
Measurement Table below and send your measurements from "A"
to "G" below to :
Made To Measure Details.
"We
will then e-mail you back with a quote, you can decide then if you want to
go ahead with the order......"
Prices for Custom-Made Shirts range
from €39.95EUR to €84.95EUR {depending on Material & Complexity of
Measurements}, plus VAT and P&P.
CLICK
HERE > View
our range of Materials Available
| A |
 |
To
measure the neck:
Place the tape around the neck. Set the tape low in the back of
the neck and bring it around the front to where the collar will
button. The tape should not be pulled tightly, rather just a true
skin measurement.
Now add 1/2 inch to your skin neck measurement to
determine your final collar size. The collar size should
always be at least 1/2 inch more than your skin neck measurement.
|
| B |
 |
To
measure Sleeve Length:
Place the tape measure at the base of the collar in the center of
the back. Measure across to the highest point of the shoulders and
down to the end of the wrist. Approximately 1/4 inch past the
point where the wrist joins the hand. |
| C |
 |
The
Yoke:
The standard yoke size is 3 inches larger than the collar
size.
Example: 15 collar with an 18 inch yoke.
You may need alittle more or less depending on your
shoulder size.
Eample: 15 collar with an 18 3/4 yoke.
|
|
To
measure the Yoke:
Place the tape measure at the edge of the shoulder.
Measure across the highest point of the shoulders to the
other edge, touching the base of the collar as you measure
across.
|
|
| D |
 |
To
measure the chest:
Place the tape around the fullest area of the back and chest.
Across the breast line of the Chest.
|
| E |
 |
To
measure Build Size:
Place the tape measure around the most prominent area of your
stomach above the trouser belt line.
|
| F |
 |
Tail
Length:
Our
Standard tail length is what we recommend. It is made to fit
your height and we always make our tail longs. However you can
also measure and select a custom tail length.
To measure the Tail Length:
Place the tape measure at the base of the collar and measure
to just below the seat of the pants. This will insure a long
enough tail to stay in your trouser.
(We recommend a 31 1/2 inch tail length for anyone 5'8"
to 5'9". A tail length of 32 1/2 inch for 5'10" to
5'11" and a tail length of 33 to 34 inches for 6 ft and
above.)
|
| G |
CUFF |
To
measure Cuffs:
Measure around the fullest area of your wrists. Enter the amount
for each wrist. The finished cuff will be made with 3 inches of
fullness over your skin wrist measurement.
If you wear a large watch add an additional 1/2 inch to that
wrist measurement to allow for the watch.
(Example: Left Wrist 7 1/4 and Right Wrist 6 3/4.) |
Send your details via our E-mail Address -
Made To Measure Details
or by phone on
:
-
International call : 00353 74 938
5882
-National
Call 074 938 5882}
"We
will then e-mail you back with a quote, you can decide then
if you
want to go ahead with the order......"
CLICK
HERE > View
our range of Materials Available
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|
Enter
our Alternative Clothing & Gifts
Catalogue
-
over 1500 Items |
|
|
|
